Printronix P7000 User Manual page 342

Chapter 7
Diagnosing Problems
Table 15. LCD Message Troubleshooting Table
Displayed Message
STACKER FAULT
STACKER FULL
STACKER JAM
TABLE MISMATCH
DOWNLOAD AGAIN
TCB CORRUPTED*
TCP PORT BUSY
342
Can User
Explanation
Correct?
Yes Stacker is not
functioning
correctly.
Yes Power stacker is
full of paper.
Yes This message is
triggered if there is
paper inside the
throat of the
stacker elevator,
but the elevator is
not moving.
No Indicates that the
software update
has failed and
should be
reloaded.
No Fatal firmware
error on controller
board.
Yes Error message
reported by the
Printer Manager
when ethernet
interface option is
installed.
Solution
Check for obstructions in
the stacker area. If fault
persists, contact your
authorized service
1
representative.
Remove paper.
1. Open the cabinet rear
door and check for
obstructions preventing
elevator movement.
Remove any
obstructions.
2. Run the print job again.
If the message appears
again, contact your
authorized service
1
representative.
Contact your authorized
1
service representative.
Contact your authorized
1
service representative.
Refer to the Printronix
P7000 PSA3 Printers
Maintenance Manual .