Printronix P7000 User Manual page 192

Chapter 4
Coax/Twinax (CTHI) Emulation
Compatibility Op
The Compatibility Options allow you to select special printer
functions in the non-SCS mode based on the capabilities of the
printer emulated.
CR At MPP+1
MPP is Maximum Print Position, which is also known as line length.
This option controls a carriage return at the end of a print line and at
MPP+1.
•
On (default). Produces a carriage return to the first print
position of the next line.
•
Off. Produces a carriage return to the first print position of the
current line.
NL At MPP+1
Controls how many lines are skipped when the carriage returns to a
new line.
•
On (default). Moves to the first print position two lines down
from the current position.
•
Off. Moves to the first print position of the next print line.
Position Aft FF (4234 only)
Allows you to select the location of the print position after a form
feed command is sent.
•
On (default). Sets the printer to print at print position 1 of the
first print line on the next form.
•
Off. Sets the printer to print at print position 2 of the first print
line on the next form.
192