Name Configs - Printronix P7000 User Manual

Chapter 4
CONFIG. CONTROL

Name Configs

You may specify a 15-character name which can be used to refer to
a configuration. The name you enter for a configuration will be used
in the Load Config., Save Config., Print Config., Delete Config., and
Power-Up Config. menus. The name can only be cleared by using
the Reset Cfg Names menu.
When you move into the Name Configs. menu, the top line of the
display shows the current configuration name. The second line of
the display is initially the same as the top line. You can modify the
second line of the display without affecting the top line until the
ENTER key is pressed, which sets the modified name.
Press the UP or DOWN (
available for that character at the cursor location. Press the NEXT
<
( ) key to move to the next character to be modified. Press the
PREV key (
Continue until you have entered the name you want to give to this
configuration, then press ENTER to save. The name you entered
will now represent this configuration on the printer's front panel. To
exit this menu without saving, press any key other than the ENTER
key. The configuration name will revert to the last saved value.
Reset Cfg Names
You can reset specific configuration names back to the default
value of the configuration number.
84
= >
or keys to cycle through the values
)
;
) to go back to a character you have already modified.