Printronix P7000 User Manual page 341

Table 15. LCD Message Troubleshooting Table
Can User
Displayed Message
Correct?
SHUTTLE STALL Yes
SOFTWARE No
ERROR*
CYCLE POWER
SPX FOUND, No
ERROR:
KEY NOT
DETECTED
SPX NOT NEEDED No
OPTIONS
ENABLED
STACK No
OVERFLOW*
STACK No
UNDERFLOW*
Explanation
The shuttle is not Set the platen lever to
moving. match the thickness of
paper, but not too tightly.
Check and adjust the
platen gap. Inspect the
ribbon mask for
deformation that snags
and interferes with shuttle
movement. If fault source
is not apparent, contact
your authorized service
representative.
Application Contact your authorized
software tried to
service representative.
perform illegal
printer function, or
damaged logic
circuits found on
controller board.
The controller Contact your authorized
board does not
service representative.
have a security
key.
Options included Contact your authorized
on the SPX are
service representative.
already installed on
the host printer.
Fatal firmware Contact your authorized
error on controller
service representative.
board.
Firmware error on Contact your authorized
the controller
service representative.
board.
Fault Messages
Solution
1
1
1
1
1
1
341