Konica Minolta AeroDR System Operation Manual page 9

Name correspondence table
Product name (Operation Manual name)
AeroDR 1417HQ
AeroDR 1417S
AeroDR 1717HQ
AeroDR Detector
AeroDR 1012HQ
AeroDR 2 1417HQ
AeroDR 2 1417S
AeroDR Interface Unit
AeroDR Interface Unit2
AeroDR Generator Interface Unit
AeroDR Generator Interface Unit2
AeroDR Battery Charger
AeroDR Battery Charger2
AeroDR Access Point
Term description
The meanings of terms used in this operation manual are as follows:
Terms
AeroDR Detector
Image processing controller
Calibration
PoE
Wired cable
Aero Sync
Access Point
AeroDR I/F Cable
AeroDR P-11
AeroDR P-12
AeroDR P-21
AeroDR P-31
AeroDR P-51
AeroDR P-52
AeroDR B-1
AeroDR Interface Unit2
AeroDR X-1
AeroDR Generator Interface Unit2
AeroDR D-1
AeroDR Battery Charger2
AeroDR C-1
Collective term indicating AeroDR 1417HQ, AeroDR 1417S, AeroDR 1717HQ,
AeroDR 1012HQ, AeroDR 2 1417HQ and AeroDR 2 1417S.
The image processing workstation (CS-7 or ImagePilot) is referred to as the image processing
controller.
Processing for calibrating the characteristics of the AeroDR Detector for each pixel.
An abbreviation for Power over Ethernet. Provides power using an Ethernet cable.
Collective term indicating AeroDR I/F Cable and AeroDR UF Cable.
This is a mode in which exposure is performed without being synchronized with the X-ray
device.
Collective term indicating the AeroDR Access Point and general-purpose access points.
The AeroDR Access Point 2 is included.
Collective term indicating the AeroDR I/F Cable (10/20m) and AeroDR I/F Cable2 (10/20m).
Model name (nameplate name)
Explanation
9
Introduction