Konica Minolta AeroDR System Operation Manual page 35

2 .2 Component names and functions
2 .2 .1 AeroDR Detector (AeroDR 1417HQ/AeroDR 1417S/
AeroDR 1717HQ/AeroDR 1012HQ)
The component names and functions of the AeroDR Detector (AeroDR 1417HQ, AeroDR 1417S,
AeroDR 1717HQ and AeroDR 1012HQ) are as follows.
(1) Triangular mark
Exposure side
(5) Exterior
(3) Antenna
display
(6) Protective
(7) LEDs
cover
Number Name
(1) Triangular mark
(2) Power switch
(3) Antenna display
(4) AeroDR Grip sheet attachment areas
(5) Exterior
(6) Protective cover
(7) LEDs
(8) Selection switch
(9) Wired connection connector
(2) Power switch
(3) Antenna display
(8) Selection (6) Protective cover
switch
• Indicates the direction to place the AeroDR Detector in during exposure.
– When exposing in portrait, place the triangular mark upward.
– When exposing in landscape, place the triangular mark to the left or right.
(Left and right are set during installation according to the exposure environment.)
Reference
• For the placement of the AeroDR Detector during exposure, refer to "3.2.2
AeroDR Detector orientation".
Used to turn the AeroDR Detector on/off.
Displays the place where a wireless antenna is attached.
• Indicates the attachment positions for AeroDR Grip sheet use.
• The AeroDR 1012HQ does not have AeroDR Grip sheet attachment areas.
Protects the internal parts.
Absorbs external shocks.
Displays the status of the AeroDR Detector.
Reference
• For the display patterns and status of the LEDs, refer to "Chapter 4 Status
(LED) Display".
Notifies the image processing controller that this AeroDR Detector will be used
for the exposure.
Connects to the AeroDR Battery Charger, AeroDR Battery Charger2, AeroDR I/F
Cable, AeroDR I/F Cable2, and AeroDR UF Cable.
35
(4) AeroDR Grip sheet attachment areas
(5) Exterior
(4) AeroDR Grip sheet
attachment areas
(9) Wired connection (6) Protective cover
connector
Functions