Konica Minolta AeroDR System Operation Manual page 60

3.3 Charging of AeroDR Detector
IMPORTANT •••••••••••••••••••••••••••••••••••••
• Handle the AeroDR Detector with extreme care when
inserting it into the AeroDR Battery Charger.
• The LED of the AeroDR Detector is not visible when
the AeroDR Detector is inserted into the AeroDR Bat-
tery Charger.
• The wired connection connector of the AeroDR De-
tector may become warm right after charging on the
AeroDR Battery Charger. This often occurs during
charging and is not a malfunction.
• • •• • • •• • • •• •••••••••••••••••••••••••••••••••• •••••••
HINT •••••••••••••••••••••••••••••••••••••
• If there is any problem during charging, the LED (or-
ange) on the AeroDR Battery Charger will light. Also,
charging will stop when an error occurs.
• • •• • • •• • • •• •••••••••••••••••••••••••••••••••• •••••••
5
Remove the AeroDR Detector from the
AeroDR Battery Charger .
• Pull the AeroDR Detector to remove it.
3 .3 .2 Charging with AeroDR
Battery Charger2
Inserting the AeroDR Detector into the AeroDR Battery
Charger2 performs charging of the AeroDR Detector.
1
Confirm that the LED (green) of the AeroDR
Battery Charger2 is slowly flashing.
2
Slowly insert the AeroDR Detector with
its exposure side pointed toward the op-
erator until the buzzer sounds . When in-
serted, charging of the AeroDR Detector
begins .
Exposure
60
side
Load slowly
Exposure
side
Inserted