Chapter 2 Charger2 - Konica Minolta AeroDR System Operation Manual

3 .4 .2 Registration with AeroDR
Battery Charger2
To register the AeroDR Detector in the AeroDR Battery
Charger2, follow the procedure below.
1
Make sure that all the devices in the destina-
tion exposure room are usable .
2
Insert the AeroDR Detector into AeroDR
Battery Charger2 in the destination expo-
sure room .
• Registration process will start.
Exposure
side
3
Once the registration is completed, a
buzzer will sound on the AeroDR Battery
Charger2, and the LED (green) will change
from slow flashing to lit.
LED (green)
4
Confirm that the AeroDR Detector icon is
displayed on the image processing control-
ler .
HINT •••••••••••••••••••••••••••••••••••••
• Charging will also start when the AeroDR Detector is
inserted into the AeroDR Battery Charger2, and the
AeroDR Battery Charger2 LED (blue) will light or flash.
•• • •• •• • •• •• •••••••••••••••••••••••••••••••••••••••••
3.4 Registration and selection of the AeroDR Detector
3 .4 .3 Registration with the
wired cable
To register the AeroDR Detector by connecting the
AeroDR I/F Cable or AeroDR UF Cable to the wired
connection connector, follow the procedures below.
1
Make sure that all the devices in the desti-
nation exposure room are usable .
2
Securely connect the AeroDR I/F Cable or
AeroDR UF Cable to the wired connection
connector on the AeroDR Detector .
• Registration process will start.
When the AeroDR I/F Cable is connected
When the AeroDR UF Cable is connected
3
Confirm that the AeroDR Detector icon is
displayed on the image processing con-
troller .
65