Konica Minolta AeroDR System Operation Manual page 68

3 .6 Position to affix AeroDR Detector identification label
and AeroDR Grip sheet
3 .6 .1 Position to affix AeroDR
Detector identification
label
When using more than 1 AeroDR Detector and affix-
ing identification labels (stickers) to the outside of the
AeroDR Detectors, it is recommended to affix the la-
bels to the 2 places ((1), (2)) shown as follows.
Position to affix AeroDR Detector identification label
Position to affix
AeroDR Detector
identification label
(recommended)
(1)
•••••••••••••••••••••••••••••••••••••
IMPORTANT
• Affix the labels only in the recommended places. Fail-
ure to do so may cause the labels to come off or image
unevenness to occur.
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
HINT •••••••••••••••••••••••••••••••••••••
• Use of commercially available vinyl (Tepra, etc.)
labels are recommended for the identification labels
(stickers). When possible, use labels that do not easily
peel off.
• It is recommended to write the name and identification
number registered in the image processing controller
on the label.
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
When using the AeroDR Grip sheet, hold the AeroDR
Detector as shown in the following figure.
Position to affix
AeroDR Detector
identification label
(recommended)
(2)
68
3 .6 .2 AeroDR Grip sheet
AeroDR Grip sheet
IMPORTANT •••••••••••••••••••••••••••••••••• • ••
• The AeroDR Grip sheet may peel off or deteriorate
depending on usage. When AeroDR Grip sheet peel
off or deteriorate, replace them.
• For replacement AeroDR Grip sheet, contact Konica
Minolta technical representatives.
• For how to affix the AeroDR Grip sheet, refer to "6.1.5
AeroDR Grip sheet affixing and replacement".
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
AeroDR
Grip sheet