Konica Minolta AeroDR System Operation Manual page 16

1.3 Safety precautions
WARNING
• If there is any smoke, odor, or abnormal sound, it
may cause a fire if use is continued, so immediately
turn the power switch off, unplug the power plug
from the wall outlet, and contact Konica Minolta
technical representatives.
• Take note of the following to reduce the risk of fire,
electric shock, or electrical leakage:
– Use specified cables for the power cable, etc.
– Use a wall outlet with the correct rating as a
power source.
– Confirm that the power plug is properly con-
nected to the wall outlet without any slack.
– Use a grounded power source.
– If you do not plan to use this device for an ex-
tended period of time, unplug the power plug.
– The supplied power cable and AC adapter are
dedicated for this device, so do not use it else-
where.
– Avoid exposure to liquid such as water.
– Make sure that foreign material, such as pieces
of metal or wire, does not get inside.
– Do not allow any metal or conductive objects to
come into contact with the spring connector of
the AeroDR Battery Charger2, AeroDR I/F Cable
or AeroDR UF Cable.
– Do not handle the power plug with wet hands.
– Do not let soil or dust accumulate on the power
plug, AeroDR Battery Charger2, AeroDR I/F Cable
or AeroDR UF Cable.
– Do not use extension cords.
– Do not connect many plugs to a single electrical
outlet.
– Do not damage the power cable, AC adapter,
AeroDR I/F Cable, or AeroDR UF Cable. Also,
do not use damaged cables.
– Do not block the ventilation openings.
• If there is any abnormality in appearance such as
deformation of the housing or a crack, stop using
the device immediately and contact Konica Minolta
technical representatives.
• Take note of the following when using this device:
– Do not use devices that emit electromagnetic
waves such as high-frequency therapy equip-
ment, mobile phones, or pocket pagers, close to
this device.
– Take note of the reception status for radios and
TVs near this device, since interference may oc-
cur in them when this device is in use.
– Use under the specified environmental condi-
tions. Failure to do so may result in degradation
of performance or malfunction.
– Limit the duration of continuous use of the
AeroDR 1012HQ in a hot and humid environ-
ment (35 to 37°C/95% or lower) in an incubator
to 25 minutes or less.
– Do not insert the AeroDR 1012HQ into the Aero-
DR Battery Charger because the charger cannot
be used for registration or charging the battery.
– Note that the AeroDR Battery Charger cannot
charge the AeroDR 2 1417S.
CAUTION
• Take the following notes when using the AeroDR
Detector:
– Use the AeroDR Detector on a flat base. If the
AeroDR Detector is placed on a sloping surface
and subjected to a load, its internal sensor may
be damaged.
– When laying the patient onto the AeroDR Detec-
tor during positioning, do so very slowly.
– When placing the AeroDR Detector under the
patient as part of the exposure process, insert
and pull out the detector slowly.
– Use the recommended adapter when you need
to perform exposure on a stretcher or a place
where load is to be applied locally.
16
CAUTION