Konica Minolta AeroDR System Operation Manual page 36

2.2 Component names and functions
2 .2 .2 AeroDR Detector (AeroDR 2 1417HQ/AeroDR 2 1417S)
The component names and functions of the AeroDR Detector (AeroDR 2 1417HQ and AeroDR 2 1417S)
are as follows.
(5) Exterior
(3) Antenna
display
(6) Protective
cover
Number
(1) Triangular mark
(2) Power switch
(3) Antenna display
(4) AeroDR Grip sheet attachment areas
(5) Exterior
(6) Protective cover
(7) LEDs
(8) Selection switch
(9) Wired connection connector
(1) Triangular mark
Exposure side
(7) LEDs (8) Selection
switch
Name
• Indicates the direction to place the AeroDR Detector in during exposure.
– When exposing in portrait, place the triangular mark upward.
– When exposing in landscape, place the triangular mark to the left or right.
• For the placement of the AeroDR Detector during exposure, refer to "3.2.2
Used to turn the AeroDR Detector on/off.
Displays the place where a wireless antenna is attached.
Indicates the attachment positions for AeroDR Grip sheet use.
Protects the internal parts.
Absorbs external shocks.
Displays the status of the AeroDR Detector.
• For the display patterns and status of the LEDs, refer to "Chapter 4 Status
Notifies the image processing controller that this AeroDR Detector will be used
for the exposure.
Connects to the AeroDR Battery Charger, AeroDR Battery Charger2, AeroDR
I/F Cable, AeroDR I/F Cable2, and AeroDR UF Cable.
(2) Power switch (4) AeroDR Grip sheet attachment areas
(3) Antenna display
(6) Protective
cover
(Left and right are set during installation according to the exposure envi-
ronment.)
Reference
AeroDR Detector orientation".
Reference
(LED) Display".
36
(5) Exterior
(4) AeroDR Grip sheet
attachment areas
(9) Wired connection
connector
Functions
(6) Protective
cover