Configuring Traffic Suppression On An Interface - Huawei Quidway S3700 Series Configuration Manual

Quidway S3700 Series Ethernet Switches
Configuration Guide - Security
No.
2
3
4

9.3.2 Configuring Traffic Suppression on an Interface

Context
Do as follows on the S3700 where traffic suppression needs to be configured.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
Step 3 Run:
{ broadcast-suppression | multicast-suppression | unicast-suppression } { percent-
value | packets packets-per-second }
Traffic suppression is configured.
Traffic suppression for three types of traffic can be configured on an interface of the S3700.
Select one of the following traffic suppression mode for the traffic on an interface:
l To configure traffic suppression based on the packet rate, you must select the packets
l To configure traffic suppression based on the bandwidth percentage, you must select the
Step 4 Run:
{ broadcast-suppression | multicast-suppression | unicast-suppression } block
outbound
Issue 01 (2011-07-15)
parameter.
percent-value parameter.
NOTE
l If traffic suppression is configured for a type of traffic on an interface, the latest configuration
overrides the previous configuration when the configuration of traffic suppression for this type of
traffic at different rate is sent.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
9 Traffic Suppression Configuration
Data
Type of traffic (broadcast, multicast, or
unknown unicast traffic) that needs to be
suppressed
Mode in which traffic is suppressed (packet
rate, rate percentage on a physical interface)
Limited rate, including packet rate,
bandwidth percentage.
215