Quidway S2700 Series Ethernet Switches
Configuration Guide - Security
No.
2
3
4
8.3.2 Configuring Traffic Suppression on an Interface
Context
Do as follows on the S2700 where traffic suppression needs to be configured.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
Step 3 Run:
{ broadcast-suppression | multicast-suppression | unicast-suppression } percent-
value
Traffic suppression is configured.
l To configure traffic suppression based on the bandwidth percentage, you must select the
----End
8.3.3 Checking the Configuration
Prerequisite
The configurations of traffic suppression are complete.
Issue 01 (2011-07-15)
percent-value parameter.
NOTE
l S2700SI does not support configuring traffic suppression for unicast-suppression.
l If traffic suppression is configured for a type of traffic on an interface, the latest configuration
overrides the previous configuration when the configuration of traffic suppression for this type of
traffic at different rate is sent.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
8 Traffic Suppression Configuration
Data
Type of traffic (broadcast, multicast, or
unknown unicast traffic) that needs to be
suppressed
Mode in which traffic is suppressed (rate
percentage on a physical interface)
Limited rate, including bandwidth
percentage.
153