Establishing The Configuration Task; Creating An Hwtacacs Server Template - Huawei Quidway S3700 Series Configuration Manual

Quidway S3700 Series Ethernet Switches
Configuration Guide - Security

1.5.1 Establishing the Configuration Task

Applicable Environment
In remote authentication or authorization mode, you need to configure a server template as
required. You need to configure an HWTACACS server template if HWTACACS is used in an
authentication or an authorization scheme.
Pre-configuration Tasks
None
Data Preparation
To configure an HWTACACS server template, you need the following data.
No.
1
2
3
4
5
6
7

1.5.2 Creating an HWTACACS Server Template

Procedure
Step 1 Run:
system-view
Issue 01 (2011-07-15)
NOTE
The S3700 does not check whether the HWTACACS template is in use when you modify attributes of the
HWTACACS server except for deleting the configuration of the server.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 AAA and User Management Configuration
Data
Name of the HWTACACS server template
IP addresses of HWTACACS authentication
authorization, and accounting servers
(Optional) Source IP address of the
HWTACACS server
(Optional) Shared key of the HWTACACS
server
(Optional) User name format supported by
the HWTACACS server
(Optional) Traffic unit of the HWTACACS
server
(Optional) Timeout interval for the
HWTACACS server to send response
packets and time when the primary
HWTACACS server is restored to the active
state
18