Step - Keysight Technologies B1505A Handbook

2-5-1-2 EasyEXPERT configuration before starting a measurement
Before starting a measurement, check the configuration for HCSMU and the module
IMPORTANT
selector. You can view and change the configuration as follows.
1. Click the configuration button
2. Select the "Dual HCSMU Combination" tab.
3. Select the "SMU Output Limit Setting" tab.
4. Select the "Module selector" tab.
1. Uncheck "Enable"
(A) "Dual HCSMU Combination" tab
Figure 2-15. 20 A Configuration setting
Make sure the checkbox is unchecked as shown in figure 2-15(A).
Make sure the Current Setting Limit is 20 A as shown in figure 2-15(B).
Make sure that Module selector is disabled as shown in figure 2-16.
on the right side of the screen.
(B) "SMU Output Limit Setting" tab
1. Uncheck "Enable"
Figure 2-16. Module Selector setting.
2. Set to 20 A
27