Keysight Technologies B1505A Handbook page 94

Step 19. Press Display Setup tab.
Step 20. The X, Y1, Y2 and so on to maximum Y8 axis can be defined as X-Y graph
Step 21. List Display sets the measurement parameters that are shown in the List
Step 22. Parameters field sets the display of extracted parameters.
Step 23. Make sure the device is properly selected as shown in the "Device used in
Step 24. The graph window pops up, and the measurement starts.
Step 25. You can see the Vcollector-Icollector curve on Y1 axis and Vbase (Y2 axis)
94
tects the Y axis value of the measurement curve at the specified X axis
point.
You can set the X-Y Graph, List Display and the Parameters of the meas-
urement results in this page.
display.
Log or Linear scale and the Min. and the Max. scale parameters are set.
area of Display Graph window.
In the example setup, Vce_sat and Vbe_sat are defined in the Auto Analy-
sis and Function Setup tabs. (Step 13 to step 18)
the example" part or your selection.
Close the lid of N1259A test fixture.
Start the measurement. (Click the Single button
graph in figure 3-36.
The marker is automatically moved to the Icollector value (X axis) specified
in the Marker function of Auto Analysis Setup, and the corresponding
Vce_sat and Vbe_sat are displayed on the Parameter field.
)