Battery Specifications; Terminal Serial Port Specifications - IBM totalstorage 2109 M12 Installation And Service Manual

San switch
Hide thumbs Also See for totalstorage 2109 M12:
Table of Contents

Advertisement

Table 14. Memory specifications (continued)
Memory type
Flash memory
Boot flash memory

Battery specifications

The CP card has a lithium carbon-monoflouride coin cell battery.
Table 15 lists the battery specifications.
Table 15. Battery specifications
Type
Rayovac BR1225
CAUTION:
Only trained service personnel may replace this battery. The battery
contains lithium. To avoid possible explosion, do not burn or charge
the battery.
Do Not:
v Throw or immerse into water
v Heat to more than 100°C (212°F)
v Repair or disassemble
Exchange only with the IBM-approved part. Recycle or discard the
battery as instructed by local regulations. In the United States, IBM
has a process for the collection of this battery. For information, call
1-800-426-4333. Have the IBM part number for the battery unit
available when you call. (C003)

Terminal serial port specifications

Each CP card provides a terminal serial port with a DB–9 connector with an
RS–232 signal subset.
Note: For dust and ESD protection, a cover is provided for the serial port and
should be kept on the port whenever the serial port is not being used.
The terminal serial port is intended primarily for use during the initial setting of the
IP address and for service purposes.
A 3.0 m (10 ft) serial cable is provided with the switch. You can convert it from a
DB–9 serial cable to an RJ–45 style serial cable by removing the adapter on the
end of the cable.
You can use the terminal serial port to connect to a computer workstation or
terminal without connecting to the fabric. The terminal device should be configured
to 9600 baud, 8 data bits, no parity, 1 stop bit, with no flow control.
The terminal serial port requires a straight through serial cable with a female 9-pin
D-SUB connector. Use the pinouts listed in Table 16 on page 88.
Amount
v User flash: 16 MB of 16–bit wide memory,
stored in two 8 MB banks
v Compact flash: 256 MB, partitioned in two
128 MB sections
512 KB of 8–bit wide memory for system
startup
Specification
3.0 volt, 50 mAh
Appendix A. Product specifications
87

Advertisement

Table of Contents
loading

Table of Contents