Table of Contents
Advertisement
Removing a filler panel
The switch accommodates the following two types of filler panels:
v A filler panel with ejectors
v A filler panel without ejectors
Perform the following steps to remove a filler panel with ejectors:
1. Push the yellow tab in on each ejector. See Figure 33.
2. Lever both ejectors all the way open.
3. Slide the filler panel out of the chassis. See Figure 34 on page 62.
Note: Filler panels without ejectors are equipped with a handle. Remove the
two captive screws, grasp the handle, and slide the filler panel out.
Direction to Push
Yellow Ejector Button
Direction to Push
Yellow Ejector Button
SJ000643
Figure 33. 16–port card filler panel
61
Chapter 6. Servicing the M12
Advertisement
Table of Contents
