Basic Safety Measures - Meiko FV 40.2 Operating Instructions Manual

Operating instructions FV 40.2 / FV 40.2 G / FV 60.2
IMPORTANT!
IMPORTANT!
IMPORTANT!
IMPORTANT!
IMPORTANT!
Datei:1_FV40_60-2_9546822_Betriebsanleitung_EN_2004-03.doc
MEIKO Maschinenbau GmbH & Co. KG, Postfach 2040, D-77652 Offenburg, Tel.: +49/781/203-0, Fax: +49/781/203-1174
install equipment for optimising energy consumption, any possible reduction in the
quality of the wash and hygiene is your responsibility.
4.2

Basic safety measures

Danger can arise from the improper use of the machine or if it is used for purposes for
which it was not intended.
Parts carrying electric current as well as moving or rotating parts can cause
• Dangers to the user's life and limb and
• Material damage
.
The machine may only be operated by adequately qualified staff who have been trained
by the operating company and who have been trained about the Hazard and Safety
Instructions.
Qualified staff, as defined by the Operating Instructions, are persons:
• who are over 14 years of age,
• who, because of their training, experience, instruction and knowledge of the relevant
standards, regulations, accident prevention instructions and operating conditions,
have been authorised by the person responsible for the safety of the machine to
carry out the necessary activities, and who therefore are aware of the possible
dangers and how to avoid them,
• who have been trained in first aid and in the on-site rescue arrangements,
• who have read and who observe the safety instructions,
• who have read and who observe the Operating Instructions (or the part applicable to
the work to be carried out).
The machine operates with hot water (Temperature of wash water = 58-60 °C, by
disinfection machine must be 74 °C). Avoid all contact with the wash water. Danger of
scalding/burning! The washed items as well as the components in contact with the wash
water have the same temperature. Please observe appropriate protective measures.
Observe all the instructions posted on the machine.
Warning !
When electrical equipment is in operation, it is inevitable that certain parts carry a
dangerous current.
ALL current to the whole machine MUST be switched off before the machine's cladding
or electrical equipment is opened.
PLACE THE (ON SITE) MAIN SWITCH IN THE "OFF" POSITION and install suitable
security measures to prevent the switch from being switched on.
Only specialist personnel may carry out repairs and rectification work on the electrical
part of the machine. The Health and Safety Regulations must be observed.
The machine may not be sprayed with a water hose or high-pressure cleaner.
The machine must only be operated under the supervision of instructed staff.
The water in the wash-up area is non-potable and can´t be used for food preparation!
If you are unsure about the operation of the machine, the machine must not be used.
Do not place any solvents or other easily flammable substances in the wash-up area,
as this increases explosion hazard
Update: 2008-03-10
W e reserve the right to change execution and construction!
S. „FV 40 G"
7/42
9544094