Capacity Of The Built-In Water Softening Device Between Two Regenerations Depends; Regeneration; Error Messages - Meiko FV 40.2 Operating Instructions Manual

Operating instructions FV 40.2 / FV 40.2 G / FV 60.2
Datei:1_FV40_60-2_9546822_Betriebsanleitung_EN_2004-03.doc
MEIKO Maschinenbau GmbH & Co. KG, Postfach 2040, D-77652 Offenburg, Tel.: +49/781/203-0, Fax: +49/781/203-1174
10.3 Capacity of the built-in water softening device between two
regenerations depends.
Water hardness
(°dH)
8
10
12
14
16
18
20
22
24
26
28
30
32
34
36
38
40
42

10.4 Regeneration

The automatic regeneration is indicated by a yellow light. The time of regeneration is 8
minutes.
A further programme sequence can take place during this time. If a second programme
cycle is started, the washing time is extended until the regeneration is completed. The
draining pause and the fresh water final rinse only take place after the regeneration is
complete.
A red light indicates when the salt container has to be re-filled.
The salt container is located in the tank. It will take approximately 1.5 kg of regeneration
salt, grain size 0.3 – 1 mm. This quantity is sufficient for about 12 regeneration cycles.
Use a funnel for adding the salt to the container. The seal and the thread of the salt
solution container must be cleaned before closing the container.

10.5 Error messages

The red light is flashing:
The water softening device is exhausted and supplies only hard water.
• Refill with salt
It is important to note that if the machine continues to be used when the water
softener is exhausted, capacity can be reduced and the machine may even become
unusable.
Update: 2008-03-10
W e reserve the right to change execution and construction!
Capacity (I)
250
200
167
143
125
111
100
91
83
77
71
67
63
59
56
53
50
48
S. „FV 40 G"
18/42
9544094