Maintenance Of Stainless Steel Surfaces; De-Scaling; Machine With Built-In Water Softening Device Aktivclean; General - Meiko FV 40.2 Operating Instructions Manual

Operating instructions FV 40.2 / FV 40.2 G / FV 60.2
IMPORTANT!
IMPORTANT!
IMPORTANT!
IMPORTANT!
Datei:1_FV40_60-2_9546822_Betriebsanleitung_EN_2004-03.doc
MEIKO Maschinenbau GmbH & Co. KG, Postfach 2040, D-77652 Offenburg, Tel.: +49/781/203-0, Fax: +49/781/203-1174
9.4.1 Safety instructions for cleaning
The tank heating element may still be hot after the tank has been emptied. There is
therefore the danger of burns when the machine is cleaned manually.
The machine, switch cabinet and other electrical components must NOT be sprayed with
a hose or a high pressure cleaner.
9.5

Maintenance of stainless steel surfaces

The appliance is made of high-quality stainless steel. Nevertheless, under special
circumstances, corrosion may occur.
To maintain stainless steel surfaces permanently free from corrosion use
• only cleaning products which are properly.
Use only products which do not attack the material, build up a film or cause
discoloration.
9.6

De-scaling

If the appliance was operated with hard water, the boiler and wash tank could have lime
scale deposits. De-scaling of the tank interior, boiler housing, tank heating, boiler heating
and wash and final rinse system then becomes necessary
For de-scaling the appliance use only products suitable for industrial dishwashers.
Please observe the instructions of the manufacturers of such products.
After de-scaling the appliance:
• Remove the de-scaling agent completely from the appliance. 1 or 2 rinse cycles with
fresh water are necessary to achieve this.
Even small residues of de-scaling agents can be sufficient to destroy plastic parts and
sealing materials! If the appliance is heavily scaled, you should ask a service engineer
from the agency responsible to de-scale the boiler.
10 Machine with built-in water softening device
AktivClean

10.1 General

The Incorporated softener AktivClean is working automatically. It must be happens
refilling the salt. The regeneration water is fed directly into the drain. It is not
necessary to drain the tank during the regeneration process. The temperature of the
feed water must not exceed 50° C.

10.2 Adjustment of water hardness

The water softening device is pre-set to 30°Gh in the factory. When the service engineer
installs or commissions the appliance he should adjust this value depending on the actual
water hardness. Should there be any further changes in the water hardness, this
parameter must be adjusted accordingly as set out in the Short Programming
Instructions.
Update: 2008-03-10
W e reserve the right to change execution and construction!
S. „FV 40 G"
17/42
9544094