Delivery, Shipping, Installation And Assembly; Delivery - Meiko FV 40.2 Operating Instructions Manual

Dish- and glasswashing machine
Table of Contents

Advertisement

Operating instructions FV 40.2 / FV 40.2 G / FV 60.2
IMPORTANT!
IMPORTANT!
IMPORTANT!
IMPORTANT!
IMPORTANT!
IMPORTANT!
Datei:1_FV40_60-2_9546822_Betriebsanleitung_EN_2004-03.doc
MEIKO Maschinenbau GmbH & Co. KG, Postfach 2040, D-77652 Offenburg, Tel.: +49/781/203-0, Fax: +49/781/203-1174
Steel scrub pads are not to be used for the pre-scouring nor for cleaning the items to be
washed.
Do not wash any metal items in the machine which are not made of stainless steel.
The in-coming of metal parts (especially iron, tinplate, copper) must absolutely be
avoided.
The appliance must not be used to transfer waste water from other sources into the
drain (Warning: risk of corrosion and blockage).
Only use suitable products for cleaning the stainless steel surfaces, which do not attack
the material, form any deposits, nor cause any discolorations.
Door and flaps MUST be closed.
Open the door very carefully during the programme cycle, as otherwise wash water
could splash out.
The tank heating element may still be hot after the tank has been emptied. There is
therefore the danger of burns when the machine is cleaned manually.
Only detergents and rinse-aids suitable for the use in industrial dishwashers may be
used.
Corresponding information is submitted by the manufacturers of such products.
Detergents and rinse agents can be injurious to health.
The manufacturers hazard instructions on the original packaging and in the safety data
sheets must be observed.
The main switch must be turned off when operation has finished.
The accompanying Operating Instructions must be observed for accessory devices, e.g.
water treatment installations.
WE ACCEPT NO LIABILITY FOR DAMAGE OR INJURY
ARISING FROM FAILURE TO OBSERVE AND ABIDE BY THESE
SAFETY INSTRUCTIONS!!!
4.2.1 Working on electrical equipment
Any repair work and repairs to the power supply on the installation's electrical equipment
may only be carried out by a qualified electrician!
Check the electrical equipment regularly! Tighten any loose connections! Replace any
damaged leads/cables immediately!
5

Delivery, shipping, installation and assembly

5.1

Delivery

Check that the delivery is complete immediately after receiving it by comparing it to
MEIKO's contract confirmation and/or the delivery note.
If necessary, complain about any missing parts immediately to the shipping company and
notify MEIKO.
Update: 2008-03-10
W e reserve the right to change execution and construction!
S. „FV 40 G"
8/42
9544094

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fv 60.2

Table of Contents