Transport, Installation And Assembly; Operating Conditions - Meiko FV 40.2 Operating Instructions Manual

Operating instructions FV 40.2 / FV 40.2 G / FV 60.2
IMPORTANT!
IMPORTANT!
IMPORTANT!
Datei:1_FV40_60-2_9546822_Betriebsanleitung_EN_2004-03.doc
MEIKO Maschinenbau GmbH & Co. KG, Postfach 2040, D-77652 Offenburg, Tel.: +49/781/203-0, Fax: +49/781/203-1174
Examine the appliance for possible transit damage.
Should you suspect any damage has occurred during shipping, you should inform:
• the shipping company,
• and MEIKO
in writing, and also send a photo of the damaged parts to MEIKO.in writing, and also
send a photo of the damaged parts to MEIKO.
Damaged appliances must not be commissioned.
5.2

Transport, installation and assembly

In order to avoid damage or life-threatening injuries during shipping of the installation, the
following points must be observed:
•
The shipping operations may only be carried out by qualified persons who
observe the safety instructions.
•
Observe transport instructions on the packing.
•
The appliance must be moved with great care.
•
Unpack the machine.
In order to ensure safe shipping, the installation parts are placed on a special four-sided
wooden frame.
Incoming goods should only arrive on these wooden frames. The packing is specifically
designed to allow the appliances to be moved safely and securely using a pallet truck.
The enclosed technical sheet indicates the connection and consumption ratings of the
appliance.
Small quantities of steam may escape from the door of the appliance. Furniture and
equipment situated near the door must be protected.
An engineer from your local MEIKO Service Centre can install the appliance at the
correct point and connect the tables - upon request. An engineer from your local
MEIKO Service Centre can install the appliance at the correct point and connect the
tables - upon request.
The following must be observed during the installation of the dishwashing machine:
•
The complete unit must be levelled in both directions using a water level.
•
Compensate for an uneven floor by adjusting the feet.
•
Table joints must be sealed with detergent-resistant sealing compound (e.g.
silicone).
5.3

Operating conditions

It is taken for granted that the planning of the system, as well as installation, setting in
operation and maintenance works are executed by sufficiently instructed staff and that
these works are checked by responsible specialists. The indications on the name plate
of the machine must correspond to the technical sheet and the local connection
conditions.
Conditions to be provided by the customer:
•
Frost free storage and installation area
•
Electrical connection in accordance with the technical sheet
•
Fresh water connection in accordance with the technical sheet
•
Waste water connection in accordance with the technical sheet
Update: 2008-03-10
W e reserve the right to change execution and construction!
S. „FV 40 G"
9/42
9544094