Getting To Know The Ec70B-Su - DFI EC70B-SU User Manual

Getting to Know the EC70B-SU

Front View
Status LED
(blue)
COM 2
COM 1
Power with LED
(green)
Reset
Antenna hole
COM 5 COM 6
Power button with LED (Green)
Press to power on or power off the system.
Status LED (Blue)
Indicates system status.
Status LED
Suspend Mode S0
LED Behavior ON
Reset Button
Press to reset the system.
COM Ports
Connect serial devices. COM 1 and COM 2 support RS232/422/485; COM 4 can be selected
between an RS232 COM port or 8-bit digital IO via jumper settings; COM 5 and COM 6
support only RS232.
VGA
(1)
Connects the VGA connector of a monitor.
HDD LED (Blue)
Indicates the status of the hard drive.
HDD LED
Disk access
HDD State
activity
LED Behavior Blink
CFast Slot (only available upon request)
Allows for convenient system capacity expansion.
USB 3.0 Ports
Connect USB 3.0 devices as well as devices based on previous USB versions.
Chapter 1 Introduction
(1)
VGA COM 4/ 8-bit DIO
HDD LED
CFast USB 3.0
Sleep S4, S5
Blinks Off
HDD present or HDD not present
Off
COM 3
Power-on Switch
(1)
Optional DP
COM Port
Connects serial devices; COM 3 supports only RS232.
Microphone/Line-out Ports
Connect audio devices such as microphones and speakers.
HDMI
(2)
Connects the HDMI connector of an LCD monitor.
USB 3.0 Ports
Connect USB 3.0 devices as well as devices based on previous USB versions.
Power-on Switch
Connects a power switch for distant power on/off control.
Gigabit LAN Ports and PoE Ports
Connect the system to a local area network. The Power over Ethernet (PoE) ports are capable
of delivering 15.4W of power to connected devices.
DC-in
DC 15~36V power input via a DC-in jack.
8-bit Digital Input/Output
Provides 8-bit digital input/output.
Notes:
1. You can choose to wire either the VGA on the front panel or the optional DP++ port on the
rear panel.
2. This is a DP/HDMI combo port. You can choose to have a DP++ port by request instead of
an HDMI port. However, make sure that you plug in an HDMI cable with the right orienta-
tion and alignment to avoid damage to the connector.
pin on the right) if the cable is not inserted correctly.
Angled-corner
Aligning side
pin
(left)
8
Line-out
USB 3.0
USB 3.0
LAN 1
LAN 2
Mic-in
(2)
HDMI
8-bit DIO
PoE
Antenna Antenna
DC-in
hole hole
You should feel resistance (due to a
Align this edge with the
Angled-corner
left side of the connector
(up)
www.dfi.com