Procedure - Keysight N2800A User Manual

5
Calibration / Deskew Procedure

Procedure

1 To perform a DC calibration / calibrated skew, make sure the 50 ohm terminator (included
with N5443A) is connected to the fixture as shown below.
2 Hold the N5443A upright and connect the fixture to the Cal Out on the oscilloscope. Turn
the nut on the Cal Out counter-clockwise to tighten.
3 While holding the fixture upright with one hand, use an 8 in. lbs. torque wrench to fully
tighten the connector as shown on the next page.
70 InfiniiMax III Series Probes User's Guide