Keysight N2800A User Manual page 51

Figure 49 Clamping the Part
2 Grab each resistor lead or wire with tweezers and pull very gently up. Touch the soldering
iron to solder joint just long enough for the resistor to come free of the probe head tip.
Figure 50 Removing the Resistor
Clean the soldering iron tip of any excess solder before using.
N OT E
The solder joint has very low thermal mass so the joint will quickly melt and release.
N OT E
To limit burning and damage to the PC board, do not keep the soldering iron in contact with
CAUTION
the tip any longer than is necessary.
Excessive dwell time with the iron will permanently damage the flip-chip resistor.
CAUTION
InfiniiMax III Series Probes User's Guide
Maintaining Probe Heads
3
51