Keysight N2800A User Manual page 32

2
InfiniiMax III Probe Heads
Figure 25 Soldering the ZIF Tip
6 Pull the ZIF handle from the ZIF tip in the direction shown in
carefully handled with your fingertips and reinserted into a plastic handle if necessary.
Figure 26 Removing the Handle from the ZIF Tip
7 You can connect ZIF tips to any of the locations on a DUT that you need to probe. The
probe head can be quickly moved between the tips.
Always mechanically strain-relieve the ZIF head before using to protect both your probe
CAUTION
accessories and DUT from damage. Refer to
Be careful not to damage the tip wires when handling the ZIF tips. Wires can be carefully
CAUTION
reshaped with tweezers or fingers if necessary.
Connecting the Probe Head to the ZIF Tip
1 Add strain relieve for the ZIF probe head as described in
Heads"
2 Form the coaxial cables to bring the probe head near the tip. Press the lever down on the
ZIF probe head (see
removes the clamping force of the connector and enables you to insert or remove ZIF tips.
Stop if you encounter any resistance at all when sliding the probe head over the ZIF tip. Check
CAUTION
your alignment, make sure the lever is pressed, and try again. Inserting the ZIF tip should
require "zero" insertion force.
32
on page 46.
Figure 27) and slide the probe head onto the tip. Pressing on this lever
Figure
"Strain Relieving the Probe Heads"
"Strain Relieving the Probe
InfiniiMax III Series Probes User's Guide
26. ZIF tips can be
on page 46.