Keysight N2800A User Manual page 40

2
InfiniiMax III Probe Heads
Figure 38 Applying Flux
4 Tin the leads with a small amount of solder.
Figure 39 Tin the Leads
5 Use tweezers to form the probe head wires to fit your DUT's geometry.
6 Flux the DUT leads and your probe head wires.
Figure 40 Applying Flux to Leads and Wires
7 Position the probe head wires on the DUT leads and quickly re-flow the solder as shown in
Figure
Do not leave the iron in contact with the probe head for more than a few seconds at a time.
CAUTION
40
41.
InfiniiMax III Series Probes User's Guide