Keysight N2800A User Manual page 21

Figure 12 Adjusting the Tip Span
Tip-Span Entry for Probe Calibration
When calibrating the probe, you will be prompted to enter the span setting on the
oscilloscope's Probe Calibration dialog box. To determine the tip span, do the following
steps:
1 Adjust the browser's tip span for your measurement.
2 Locate the tip-span gauge on the browser's protective cap as shown in
3 Determine which of the three possible tip-span settings most closely matches the
browser's tip span.
Figure 13 Tip Span Gauge on Browser Protective Cap
InfiniiMax III Series Probes User's Guide
InfiniiMax III Probe Heads
Figure 13.
2
21