Displaying The Snmp Settings - HPE FlexFabric 5700 Series Network Management And Monitoring Configuration Manual

Step
3. (Optional.) Configure a
source address for
notifications.
4. (Optional.) Enable
extended
linkUp/linkDown
notifications.
5. (Optional.) Configure
the notification queue
size.
6. (Optional.) Configure
the notification lifetime.
7. (Optional.) Configure
the interval for sending
periodic notifications.

Displaying the SNMP settings

Execute display commands in any view. The display snmp-agent community command is
supported only in non-FIPS mode.
Task
Display SNMP agent system information, including
the contact, physical location, and SNMP version.
Display SNMP agent statistics.
Display the local engine ID.
Display SNMP group information.
Display remote engine IDs.
Display basic information about the notification
queue.
Display the modules that can generate notifications
and their notification status (enable or disable).
Display SNMPv3 user information.
Display SNMPv1 or SNMPv2c community
information. (This command is not supported in FIPS
mode.)
Command
securityname security-string { v2c |
v3 [ authentication | privacy ] }
In FIPS mode:
snmp-agent target-host inform
address udp-domain { target-host |
ipv6 target-host } [ udp-port
port-number ] [ vpn-instance
vpn-instance-name ] params
securityname security-string v3
{ authentication | privacy }
snmp-agent { inform | trap } source
interface-type interface-number
snmp-agent trap if-mib link extended
snmp-agent trap queue-size size
snmp-agent trap life seconds
snmp-agent trap periodical-interval
interval-time
Command
display snmp-agent sys-info [ contact | location |
version ] *
display snmp-agent statistics
display snmp-agent local-engineid
display snmp-agent group [ group-name ]
display snmp-agent remote [ ip-address
[ vpn-instance vpn-instance-name ] | ipv6
ipv6-address [ vpn-instance vpn-instance-name ] ]
display snmp-agent trap queue
display snmp-agent trap-list
display snmp-agent usm-user [ engineid engineid
| username user-name | group group-name ] *
display snmp-agent community [ read | write ]
92
Remarks
By default, SNMP uses the IP
address of the outgoing routed
interface as the source IP
address.
By default, the SNMP agent
sends standard linkup/linkDown
notifications.
By default, the notification queue
can hold 100 notification
messages.
The default notification lifetime is
120 seconds.
The default is 60 seconds.