Local Port Mirroring With Multiple Monitor Ports Configuration Example - HPE FlexFabric 5700 Series Network Management And Monitoring Configuration Manual

Monitor port: Ten-GigabitEthernet1/0/2
Remote probe VLAN: 2
# Display information about all mirroring groups on Device A.
[DeviceA] display mirroring-group all
Mirroring group 1:
Type: Remote source
Status: Active
Mirroring port:
Ten-GigabitEthernet1/0/1
Monitor egress port: Ten-GigabitEthernet1/0/2
Remote probe VLAN: 2
The output shows that you can monitor all packets received and sent by the Marketing department
on the server.
Local port mirroring with multiple monitor ports configuration
example
Network requirements
As shown in
traffic of the three departments.
Figure 62 Network diagram
Dept. A
Dept. B
Dept. C
Configuration procedure
# Create remote source group 1.
<DeviceA> system-view
[DeviceA] mirroring-group 1 remote-source
# Configure Ten-GigabitEthernet 1/0/1 through Ten-GigabitEthernet 1/0/3 as source ports of the
remote source group.
[DeviceA] mirroring-group 1 mirroring-port ten-gigabitethernet 1/0/1 to
ten-gigabitethernet 1/0/3 both
# Configure an unused port (Ten-GigabitEthernet 1/0/5, for example) of Device A as the reflector port
of the remote source group.
Figure 62, configure port mirroring so servers A, B, and C can monitor the bidirectional
XGE1/0/2
Both
XGE1/0/1
XGE1/0/11
DeviceA
XGE1/0/12
XGE1/0/13
XGE1/0/3
178
ServerA
ServerB
ServerC