Dlsw Operation Configuration Example - HPE FlexFabric 5700 Series Network Management And Monitoring Configuration Manual

RTT number: 4000
Min positive SD: 1
Max positive SD: 360
Positive SD number: 1030
Positive SD sum: 4363
Positive SD average: 4
Positive SD square-sum: 497725
Min negative SD: 1
Max negative SD: 360
Negative SD number: 1028
Negative SD sum: 1028
Negative SD average: 4
Negative SD square-sum: 495901
One way results:
Max SD delay: 359
Min SD delay: 0
Number of SD delay: 4
Sum of SD delay: 1390
Square-Sum of SD delay: 483202
SD lost packets: 0
Lost packets for unknown reason: 0
Voice scores:
Max MOS value: 4.38
Max ICPIF value: 0

DLSw operation configuration example

Network requirements
As shown in
Figure 49 Network diagram
Configuration procedure
# Assign each interface an IP address. (Details not shown.)
# Configure static routes or a routing protocol to make sure the devices can reach each other.
(Details not shown.)
# Create a DLSw operation.
<DeviceA> system-view
[DeviceA] nqa entry admin test1
[DeviceA-nqa-admin-test1] type dlsw
# Configure 10.2.2.2 as the destination IP address.
[DeviceA-nqa-admin-test1-dlsw] destination ip 10.2.2.2
# Enable the saving of history records.
Figure 49, configure a DLSw operation to test the response time of the DLSw device.
Min positive DS: 1
Max positive DS: 1297
Positive DS number: 1024
Positive DS sum: 5423
Positive DS average: 5
Positive DS square-sum: 2254957
Min negative DS: 1
Max negative DS: 1297
Negative DS number: 1022
Negative DS sum: 1022
Negative DS average: 5
Negative DS square-sum: 5419
Max DS delay: 985
Min DS delay: 0
Number of DS delay: 4
Sum of DS delay: 1079
Square-Sum of DS delay: 973651
DS lost packets: 0
Min MOS value: 4.38
Min ICPIF value: 0
153