Installing The Controller; Installing The Touch Panel/Pad; Onecontrol Touch Panel - Lippert Components Ground Control TT Installation And Owner's Manual

4. Connect the sensor harness to the 3-pin Deutsch
Connector on the sensor (Fig.20A) and run the harness
through the frame and up to the compartment where the
controller will be mounted.
Fig.20

Installing the Controller

NOTE: Prior to starting this portion of the installation,
double check that all of the harnesses are properly and
securely connected to the leveling jacks, Power Tongue
Jack, and leveling sensors.
NOTE: The compartment where the controller will be
installed must be protected from the elements and the
controller must be installed in compliance with RVIA Gas
Codes, as the controller connections are not spark-proof.
1. Using four #8 X 1" wood screws (Fig.21B), attach the
controller (Fig.21A) to the compartment wall or ceiling.
B
Fig.21
lippertcomponents.com
A
A
574-537-8900
Ground Control
Leveling OneControl
Touch Panel
Installation and Owner's Manual
(For Aftermarket Applications)
2. Attach the power and ground harnesses to the
corresponding posts on the controller with the provided
keps nuts and then connect the harnesses to the correct
posts on the trailer battery.
3. Connect all jack harnesses to the appropriate connectors
on the controller (see the "Wiring Diagram" section).

Installing the Touch Panel/Pad

OneControl Touch Panel

1. Determine where to mount the OneControl Touch Panel.
The touch panel can be mounted anywhere inside the
trailer or trailer compartment. The mounting location must
be watertight. The typical location for the touch panel is
near the entry door.
2. Dry fit the mounting bracket where the controller will
be located.
3. Cut a hole in the wall of the compartment using the
inside opening of the bracket as a guide. Use the bracket
to trace where the cut-out should be located. The top and
bottom horizontal cuts should be parallel to the floor of the
trailer or trailer compartment.
4. Secure the mounting bracket with the 4 provided ¼" pan
head Phillips sheet metal screws (Fig.22).
Fig.22
5. Feed the touch panel harness (signal to the touch panel)
and canbus power connector (power to the touch panel)
through the bracket and run to the compartment where the
controller is mounted. Plug the harness and canbus power
connector into the appropriate connectors on the controller
(See the "Wiring Diagram" section.)
10
Rev: 08.17 - GC
TT
®
TT Leveling OneControl
®
®
Touch Panel
®