Lippert Components Ground Control TT Installation And Owner's Manual page 9

The Leveling Sensors (Fig.15) must be oriented on the
crossmembers with the arrows on the top of the sensor
pointing in the correct direction (Fig.16). See (Fig.14),
sections A and B, for location clarification.
Fig.15
NOTE: The following process will be repeated for both
sensor installations.
NOTE: If the frame is Ground Control Travel Trailer ready,
it may be possible that the Leveling Sensor Mounting Plate
may have already been pre-installed onto the frame.
1. Dry fit the mounting plate (Fig.17C) and the leveling
sensor (Fig.17B) to the crossmember (Fig.17A). The
pre-drilled holes closest to the rounded edges are for
mounting the sensor to the plate. Mark on the plate where
the sensor will set.
Fig.17
NOTE: Ensure there is a space between the sensor and
crossmember so the wire harness is not pinched.
lippertcomponents.com
Fig.16
A
B
C
574-537-8900
Ground Control
Leveling OneControl
Touch Panel
Installation and Owner's Manual
(For Aftermarket Applications)
NOTE: The wire harness must be pointed toward the
front of the trailer. Orientation is imperative for the correct
operation of the leveling system.
2. Attach the sensor (Fig.18A) to the mounting plate
(Fig.18B) using two #12 X 1
NOTE: To avoid cracking the mounting sensor housing, do
not over-tighten the screws.
Fig.18
3. Attach the mounting plate and sensor assembly
(Fig.19B) to the crossmember (Fig.19A) using two #12 X 1"
screws (Fig.19C). Ensure that the plate is centered side to
side on the frame and that the sensor is oriented properly.
See (Fig.14) sections A and B for location clarification.
X
Fig.19
9
Rev: 08.17 - GC
®
TT
®
"
screws (Fig.18C).
A
B
C
X A
B
C
TT Leveling OneControl
®
®
Touch Panel