Auto Leveling Control Touch Pad - Lippert Components Ground Control TT Installation And Owner's Manual

NOTE: It is recommended to wire the canbus power
connector to the controller. The canbus power connector
MUST be powered from a fused power source. Failure
to provide circuit protection could cause damage to the
system.
NOTE: This system requires two terminating resistors: one
at the controller and one on the back of the OneControl
Touch Panel.
6. Insert the touch panel into the mounting bracket. Align
the 4 slots on the back of the OneControl Touch Panel
with the 4 tabs (Fig. 23A) on the mounting bracket.
Gently push the OneControl in and then slide down. The
mounting bracket has 2 screw mounting tabs on the bottom
(Fig. 23B). Secure the touch panel into the screw mounting
tabs using the 2 provided pan head phillips sheet metal
screws.
A
B
Fig.23
lippertcomponents.com 574-537-8900
Ground Control
Leveling OneControl
Touch Panel
Installation and Owner's Manual
(For Aftermarket Applications)

Auto Leveling Control Touch Pad

1. Determine where to mount the Auto Leveling Control
Touch Pad. The touch pad should be mounted on the
exterior of the trailer so the operator will have a view of the
coupler during operation.
2. Cut a hole in the desired location 1
and have a depth of
horizontal cuts are parallel to floor of the compartment or
floor of the unit.
5/8
"
3/4
1
"
Fig.24
3. Plug the touch pad harness into the connector on
the back of the touch pad to ensure that the product is
functional before mounting.
4. Feed the touch pad harness through this hole and run
it to the compartment where the controller is mounted
(Fig.25). Plug the harness into the appropriate connector
on the controller.
5. Attach the touch pad with four #8 X 1
(Fig.25A).
A
Fig.25
11
Rev: 08.17 - GC
TT
®
3/4
" wide by 1
5/8
" (Fig.24) so the top and bottom
compartment
wall
1/4
1
"
"
wood screws
TT Leveling OneControl
®
®
1/4
" high
Touch Panel
®