Front Spacer Kit; C-Jack Installation - Lippert Components Ground Control TT Installation And Owner's Manual

3/8
13. Insert four " hex cap screw bolts (Fig.7A) with
flat washer through the spacer bracket and center tube.
3/8
Secure with " flat washer and
to 13 ft-lbs.
A
Fig.7

Front Spacer Kit

1. Measure the I-beam mounting bracket and make a mark at
the center. This will be the center of the C-Jack foot pad.
2. Measure from the front of the frame and make a mark
at 60". This will be the maximum allowable distance for the
location of the center of the C-Jack foot pad. The final location
should be as close to the draw bar as possible, staying within
the approach angle (Fig.1). Ensure the bracket lip (similar to
Fig.2C) is flush with the outside lip of the I-beam.
3. Repeat steps 3 -13 for "Bolt on Spacer Kit." (Substitute steps
1 and 2 above at step 7.)

C-Jack Installation

1. For all 4 C-Jack locations, align the C-Jack mounting
holes with the holes on the I-beam mounting bracket
across the frame roadside to curbside (Fig.8).
NOTE: Use the optional aid of a hydraulic floor jack to
assist in holding the C-Jack in place or manually open the
C-Jack so that the foot pad is touching the ground. See
the "Troubleshooting" section "Manual Override" to fully
extend the C-Jack. If the C-Jack has tabs, insert the tabs
into the slots on the I-beam mounting bracket to assist with
installation until secured.
3/8
2. Insert six " flange bolts (Fig.8A) through each set of
aligned I-beam mounting brackets, 4 at the I-beam end
and 2 on the opposite end.
lippertcomponents.com
3/8
"
3/8
" nylon lock nut. Torque
A
574-537-8900
Ground Control
Leveling OneControl
Touch Panel
Installation and Owner's Manual
(For Aftermarket Applications)
3. Secure the bolts with a
3/8
" flange nut (Fig.8C). Torque to 23 ft-lbs.
4. Connect the 3-pin Deutsch Connector to the C-Jack
motor wires (Fig.8F) and run the harnesses to the
compartment where the controller will be mounted.
(See "Installing the Controller" section.)
NOTE: LCI recommends zip tying the harnesses tight
against the front jack motors to prevent damage to the
harnesses.
D
E
B
C
Fig.8
6
Rev: 08.17 - GC
®
TT
®
3/8
" flat washer (Fig.8B) and a
A
TT Leveling OneControl
®
®
F
Touch Panel