Lippert Components Power Gear Owner's Manual
Lippert Components Power Gear Owner's Manual

Lippert Components Power Gear Owner's Manual

Automatic leveling with touch pad
Hide thumbs Also See for Power Gear:

Advertisement

Quick Links

Power Gear
®
Automatic Leveling
with Touch Pad 140-1229
OWNER'S MANUAL
(82-L0379)

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Power Gear and is the answer not in the manual?

Questions and answers

Summary of Contents for Lippert Components Power Gear

  • Page 1 Power Gear ® Automatic Leveling with Touch Pad 140-1229 OWNER'S MANUAL (82-L0379)
  • Page 2: Table Of Contents

    The use of the Power Gear Electronic Leveling System to support the coach for any reason other than which it is intended is prohibited by Lippert’s limited warranty. The Power Gear leveling system is designed as a “leveling”...
  • Page 3: Safety

    Safety Read and understand all instructions before installing or operating this product. Adhere to all safety labels. This manual provides general instructions. Many variables can change the circumstances of the instructions, i.e., the degree of difficulty, operation and ability of the individual performing the instructions. This manual cannot begin to plot out instructions for every possibility, but provides the general instructions, as necessary, for effectively interfacing with the device, product or system.
  • Page 4: Preparation

    It will signal that it has completed the process by illuminating the center green Power Gear LEVEL (Fig.1E) light. Check to make sure that all jacks are on the ground. Also check to make sure that no tire is off the ground.
  • Page 5: Manual Operation

    Manual Operation Leveling Coach There are certain conditions where manually leveling your coach may be desirable. Conditions where large amounts of side to side leveling are necessary or when one or more tires are off the ground at the end of the auto-level sequence, it may work better using the manual leveling procedures that follow: Turn on the ignition and start the coach.
  • Page 6: Manual Override

    In case of a loss of power at the pump assembly, the manual override valves (MOV’s) can be used to retract the leveling jacks. Not all Power Gear leveling system pumps have manual override valves. Power units for double acting systems that have manual override valves have flexible rubber caps on the valves and a hex override nut under the plastic cap on the electric motor.
  • Page 7: Maintenance

    Hydraulic Fluid Recommendation The Power Gear Electronic Leveling System is pre-filled, primed and ready to operate direct from the manufacturer. Type “A” Automatic Transmission Fluid (ATF) is utilized and will work. ATF with Dexron III® or Mercon 5®...
  • Page 8: Troubleshooting

    Troubleshooting The following chart contains troubleshooting tips if your system is not operating properly, and the touch pad is not giving you a trouble code. Description Probable Cause Corrective Action Coach ignition not in Turn on the ignition and start the coach. The run position engine must be running for the jacks to operate.
  • Page 9: Normal Operation: Indicator Light Descriptions

    The coach is already level in its current state. Already The Power Gear logo is flashing Power Gear logo Leveling can still be Level indefinitely completed as normal (to stabilize coach)
  • Page 10: Diagnostic Troubleshooting Codes: Indicator Light Descriptions

    Diagnostic Troubleshooting Codes: Indicator Light Descriptions The following chart contains troubleshooting tips if system is not operating properly, but the touch pad is supplying a trouble code. Flashing Fault Description of Probable Cause Corrective Action Lights Code Operation Ignition ON, start coach. Low Voltage light ON, Allow batteries to charge.
  • Page 11: Notes

    Notes Page 11 Rev: 11.23.22 CCD-0004307...
  • Page 12 The contents of this manual are proprietary and copyright protected by Lippert. Lippert prohibits the copying or dissemination of portions of this manual unless prior written consent from an authorized Lippert representative has been provided.  Any unauthorized use shall void any applicable warranty.  The information contained in this manual is subject to change without notice and at the sole discretion of Lippert. ...

This manual is also suitable for:

140-1229

Table of Contents