Apply Touch Screen Protective Film; Installation - Honeywell Thor VM3 User Manual

Apply Touch Screen Protective Film

The optional Thor VM3 touch screen protective film is shipped in packs of 10. The pro-
tective film is flexible and treated with an anti-glare coating on the outer surface.

Installation

1. Make sure the touch screen is clean and dry before installation. See
2. Pull the release tab to separate the protective backing from the rear of the protective
3. Place the rear side of the protective film against the Thor VM3 display, roughly
4. Slide the protective film until one corner can be slid back between the touch screen
5. Slide the protective film away from the other bottom corner. The film may bulge
6. Repeat with each of the top corners, sliding the protective film away from the corner
7. It may be necessary to flex the protective film during the install, however use care
8. Once all corners are secure under the display housing, adjust the protective film, if
122
instructions on suitable cleaning agents.
film. Avoid touching the rear side of the protective film while removing the liner.
centering the protective film over the display.
and the display housing as the protective film is re-centered on the display. It may
be necessary to press the edges of the protective film against the display to ensure
the entire edge slides under the display housing. It is easiest to start with one of the
bottom corners.
slightly away from the Thor VM3 as it is being slid. Only slide the protective film
enough so that the protective film can slide under the display housing on that
corner when the protective film is returned to center.
just enough that the protective film can slide under the display housing when the
protective film is returned to center.
not to flex the protective film so much that the protective film kinks.
necessary, so it is centered on the touch screen.
Thor VM3 with Microsoft Windows Embedded Compact 7 User Guide
The protective film is slightly larger than
the Thor VM3 touch screen, however the
notches on the edge of the protective
film (indicated by the arrows) corre-
spond to the display size of the Thor
VM3. The protective film is not adhesive.
The corner edges are designed to fit
between the Thor VM3 display and the
display housing to hold the protective
film in place.
A protective backing is applied to the
rear surface of the protective film. A pull
Pull Tab
tab is attached to the protective backing
for easy removal of the protective back-
ing from the film.
Cleaning for