Honeywell Thor VM3 User Manual page 99

15. Use proper electrical and mechanical fastening means for terminating the cable.
16. Provide mechanical support for the cable by securing it to the vehicle structure at
17. Connect the watertight connector end of the power cable to the Thor VM3 dock
18. Secure the power cable to the Thor VM3 using the
19.
20. If using the
21. Press the
22. Press the
Note: Ignition control is not available for trucks over 60VDC.
Wiring Diagram
See Caution
statement
below
Caution: For battery powered vehicles:
•
Caution: For internal combustion engine powered vehicles:
•
Thor VM3 with Microsoft Windows Embedded Compact 7 User Guide
Properly sized "crimp" type electrical terminals are an accepted method of
termination. Select electrical connectors sized for use with 18AWG (1mm
conductors.
approximately one foot intervals, taking care not to over tighten and pinch
conductors or penetrate the outer cable jacket.
power connector by aligning the connector pins to the power connector; push down
on the watertight connector and twist it to fasten securely. Flip the power switch on
the back of the dock to On.
Place Thor VM3 in the Dock
Screen Blanking
Power Switch
Power Button
Existing Circuitry on Vehicle
Forklift Battery
Main Switch
+Vo -Vo
Fuse - See
Warning
statement below
GND V + V -
IN IN
V +
O
V -
O
DC/DC
Power
Supply
GND must be connected to the vehicle chassis ground.
GND is connected to the vehicle chassis ground, which can also be battery negative.
feature, install the screen blanking box or switch.
on the back of the Thor VM3 dock.
on the front of the Thor VM3 to turn on the Thor VM3.
User supplied serial
cable for optional
screen blanking
connection,
see below
Strain Relief Cable Clamps.
Quick Mount
Smart Dock
COM1 or COM2
Connector
on Dock
Red/White (if present)
Red
Black/White (if present)
Circular
Power
Black Connector
on Dock
Green
Blue
(not connected)
2
)
87