Troubleshooting - Honeywell Thor VM3 User Manual

Manual Connect
1. Select Bluetooth Scanning from the Control Panel (either large or small icon view
2. Tap Add Device.
3. Select Manual.
4. Tap Next.
5. Enter the MAC address of the Bluetooth scanner.
6. Tap Next.

Troubleshooting

•
•
•
•
•
•
•
Thor VM3 with Microsoft Windows Embedded Compact 7 User Guide
option must be selected).
The Honeywell Xenon 1902 Bluetooth scanner does not work with Quick Connect. It
must be connected using the Search or Manual options.
Make sure the scanner is in the correct mode. Bar codes to set the mode can be found
in the manual provided with the Bluetooth scanner.
• The scanner must be a master device to use the Quick Connect option.
• The scanner must be a slave device to use the Search or Manual option.
The Motorola/Symbol LS3578 family of scanners may not support the Quick
Connect feature (depending on firmware installed). If Quick Connect does not work,
use the other options to connect these scanners.
If the Honeywell Granit 1911i and Granit 1981i scanners cannot be found with the
Search option, scan the PDAs/Mobility Systems Devices bar code from the scanner
manual and search again.
If the Honeywell Granit 1911i and Granit 1981i scanners cannot connect using the
manual option, scan the PDAs/Mobility Systems Devices bar code from the
scanner manual then repeat the manual add process again.
If the Honeywell Granit 1911i and Granit 1981i scanners are not removed after using
the Remove option, the auto-reconnect option is enabled on the Granit scanner (this
is the default option). To remove the scanner:
• Scan the disable auto-reconnect bar code from the Granit scanner manual then
tap Remove, or
• Scan BT_RMV to unlink and disconnect the scanner the tap Remove.
If a Honeywell/LXE ring scanner is not connecting, scan the Restore Factory
Defaults bar code in the scanner manual and try connecting again.
159