Honeywell Thor VM3 User Manual page 210

•
•
Result
The Thor VM3 continues to run and follows the AC/DC power scheme with timers reset
at the time power was connected.
Ignition Control Mode
In Ignition mode, the Thor VM3 is turned On when the ignition switch is activated with
no user interaction required. The ignition input wire must be connected.
Note: When the UPS battery has been depleted or disconnected (the Thor VM3 is first powered
out of the box, the front panel has been replaced, etc.) power the Thor VM3 manually by
pressing the power button. After the initial power up, the Thor VM3 powers on
automatically when the Ignition Control Mode is enabled and the ignition is turned on.
Note: When ignition control is used to power the Thor VM3 on automatically the
must be enabled.
Thor VM3 is Off and Vehicle Ignition is Off
Conditions
The Thor VM3 is Off and vehicle ignition is Off.
Result
The Thor VM3 remains Off regardless of external power. UPS charging is disabled.
Conditions
The Thor VM3 has external power but vehicle ignition is Off. The Power button is
pressed.
Result
The Thor VM3 boots. Once booted the Thor VM3 follows the Ignition Control/Ignition
Off power scheme with timers reset after the boot completes.
Thor VM3 is Off and Vehicle Ignition is Switched to On
Conditions
The Thor VM3 is Off and vehicle ignition changes from Off to On.
Result
The Thor VM3 boots. Once booted the Thor VM3 follows the Ignition Control/Ignition
On power scheme with timers reset after the boot completes.
Thor VM3 is On and Vehicle Ignition is Switched to On
Conditions
The Thor VM3 is On and vehicle ignition changes from Off (or not present) to On.
198
Thor VM3 is already mounted to a dock and external power is applied to the dock
Thor VM3 is already mounted to a dock and the dock power switch is turned On
Thor VM3 with Microsoft Windows Embedded Compact 7 User Guide
Wakeup Timer