Honeywell Thor VM3 User Manual page 119

External AC/DC Power Supply
These instructions for use with
only.
The optional external AC/DC power supply is for use in environments, such as an office,
where DC power is not available.
Note: The Honeywell-approved AC/DC Power Supply and Adapter Cable are only intended for
use in a 40ºC (104ºF) maximum ambient temperature environment.
In North America, this unit is intended for use with a UL Listed ITE power supply with
output rated 15 VDC, 4 Amp (maximum), 60 W (maximum). Outside North America, this
unit is intended for use with an IEC certified ITE power supply with output rated 15 VDC,
4 Amp (maximum), 60 W (maximum).
The external power supply may be connected to either a 120V, 60Hz supply or, outside
North America, to a 230V, 50Hz supply, using the appropriate detachable cordset. In all
cases, connect to a properly grounded source of supply provided with maximum 15
Amp overcurrent protection (10 Amp for 230V circuits).
Connect External Power Supply
1. Connect the provided detachable cordset (US only, all others must order cable sepa-
2. Plug cordset into appropriate, grounded, electrical supply receptacle (AC mains).
3. Connect the DC output cable end to the corresponding connector on the adapter
4. Connect the watertight connector end of the Adapter Cable to the VMXD Off-Vehicle
5. Press the
6. Press the
Thor VM3 with Microsoft Windows Embedded Compact 7 User Guide
AC Input Cable (US only)
rately) to the external power supply (IEC 320 connector).
cable.
Dock power connector by aligning the connector pins to the power connector; push
down on the watertight connector and twist it to fasten securely.
Power Switch
Power Button
VMXD Enhanced Dock for Off-Vehicle Use
To DC Output Cable
on the back of the Thor VM3 dock.
on the front of the Thor VM3 to turn on the Thor VM3.
DC Output Cable
To Dock
107