Honeywell Thor VM3 User Manual page 140

6. Locate the SIM card holders. The
Note: If an mSATA drive has been installed, it is necessary to remove the drive before installing
the SIM card(s).
7. Slide the silver retainer clip toward the center of the Thor VM3.
8. After the clip is slid in, lift the outer edge of the SIM holder so it is at a 45º to 90º
9. Insert the SIM card into the SIM holder.
Note: The SIM card does not have a "spring lock" type holder. Slide the SIM card into the holder
but do not push it expecting it to lock into place. The SIM card will be held in place when
the card holder is closed.
10. Lower the SIM holder to back to its flat position.
11. Slide the silver retainer clip back toward the outside edge of the Thor VM3. This locks
12. Reattach the access panel, torquing the screws to 7.0 ± 0.5 inch pounds.
13. Reinstall the Thor VM3 in the dock.
14. Resume the Thor VM3 from Suspend.
128
identifies the top slot (the slot closest to the top of the Thor VM3 as
slot 1 (SIM 1) and the lower slot as slot 2 (SIM 2).
angle (compared to the circuit board on which it is mounted).
SIM
the SIM card in place.
Thor VM3 with Microsoft Windows Embedded Compact 7 User Guide
VM3 WWAN Connection Manager