Disabling Ethernet Bridging (In-Dock Communications); About Batch Configuration; Select A Touch Screen Profile To Optimize Performance - Honeywell Dolphin CN80 Series User Manual

Disabling Ethernet Bridging
(In-Dock Communications)
When you place the terminal in the charging dock and establish a connection with
a host PC through Ethernet communications, the WLAN radio is deactivated. When
the session is dropped, the WLAN radio returns to its previous state. Bluetooth
communications, if activated, are not affected.
Note: The charging dock only has a USB connector. For Ethernet support, you need to
attach an Ethernet adapter to the charging dock. To order an Ethernet adapter,
contact your Honeywell representative.

About Batch Configuration

Honeywell Batch mobile computers are manufactured without RF transmission
capabilities. Once a device is manufactured as a Batch device it has no capability
of any RF transmission. There is no firmware or software that can be added to the
device that will allow it to transmit an RF signal.
•
Note: RF transmission cannot be turned on in the field accidentally or purposely.

Select a Touch Screen Profile to Optimize Performance

Optimize screen interactions by selecting a touch screen profile designed
specifically for your use case. For example, if you wear gloves, set the touch screen
profile to Glove use enhanced for the best touch screen response.
Note: Maximum glove thickness of 2 mm (0.08 inches) for touch screen response.
1. Swipe up from the bottom of the Home screen to access all apps.
2. Tap Settings
3. Choose one of the following options:
4. Exit the Settings app.
18
CN80G-L0N-6EN241F – 4 designates Batch Configuration
> Honeywell Settings > Touch Screen Profiles.
• Normal mode
• Finger enhanced mode
• Glove enhanced mode
• Stylus enhanced mode
Dolphin CN80 Mobile Computer