Honeywell Thor VM3 User Manual page 199

Misc
Options on this tab configure device specific options. Note that options not available on
the Thor VM3are dimmed or grayed out.
CapsLock
By default, CapsLock is off after a warmboot. Check this box to turn CapsLock on after a
warmboot.
Touch Screen Disable
By default, the Thor VM3 touch screen is enabled. To disable the touch screen after a
warmboot, click this checkbox.
Note: If the touch screen is disabled on a Thor VM3, you must use a USB mouse or keyboard
attached to the Thor VM3 to access this tab to re-enable the touch screen unless a key has
been assigned to enable the touch screen using
Enable Keypad Backlight
By default, the keypad backlight default setting is to follow the display backlight setting
until it is changed by the user.
Click the checkbox to disable the keypad backlight.
This keypad backlight setting only applies to the integrated keypad on the Thor VM3.
The keyboard backlight on an attached USB keyboard is not affected by this setting.
USB Powered in Suspend
By default, power to attached USB devices is turned off when the Thor VM3 is in Sus-
pend mode. Check this box to maintain power to attached USB devices in Suspend.
The external keyboard is a USB device. If USB devices are not powered in Suspend the
external keyboard backlight turns off when the Thor VM3 enters Suspend.
5V on COM1
By default, Pin 9 of COM1 provides +5V, such as for an external scanner tethered to the
COM1 port. Uncheck this box to configure Pin 9 of COM1 to provide RI.
Thor VM3 with Microsoft Windows Embedded Compact 7 User Guide
Keyboard Remapper.
187