Honeywell Thor VM3 User Manual page 104

15. Provide mechanical support for the cable by securing it to the vehicle structure at
16. Connect the watertight connector end of the power cable to the Thor VM3 dock
17. Secure the power cable to the Thor VM3 using the
18.
19. If using the
20. Press the
21. Press the
Note: Ignition control is not available for trucks over 60VDC.
Wiring Diagram
See Caution
statement below
Caution: For battery powered vehicles:
must be connected to the vehicle chassis ground.
Caution: For internal combustion engine powered vehicles:
is connected to the vehicle chassis ground, which can also be battery negative.
92
approximately one foot intervals, taking care not to over tighten and pinch
conductors or penetrate the outer cable jacket.
power connector by aligning the connector pins to the power connector; push down
on the watertight connector and twist it to fasten securely. Flip the power switch on
the back of the dock to On.
Place Thor VM3 in the Dock
Screen Blanking
Power Switch
Power Button
Existing Circuitry on Vehicle
Forklift Battery
Main Switch
+Vo -Vo
Fuse - See
Warning
statement below
+ -
+
-
DC/DC
Power
Supply
Thor VM3 with Microsoft Windows Embedded Compact 7 User Guide
feature, install the screen blanking box or switch.
on the back of the Thor VM3 dock.
on the front of the Thor VM3 to turn on the Thor VM3.
User supplied serial
cable for optional
screen blanking
connection,
see below
Strain Relief Cable Clamps.
Quick Mount
Smart Dock
COM1 or COM2
Connector
Red/White (if present)
Red
Black/White (if present)
Power
Black
Connector
Green
Blue
(not connected)