Honeywell Thor VM3 User Manual page 89

Vehicle 10-60VDC Direct Power Connection
1. The Thor VM3 must not be mounted in the dock. The power switch on the dock must
2. While observing the
3. Use proper electrical and mechanical fastening means for terminating the cable.
4. Refer to the wiring diagrams following this section for wire colors and connections:
5. Route the power cable the shortest way possible removing any left-over cable. The
6. Provide mechanical support for the cable by securing it to the vehicle structure at
7. Connect the watertight connector end of the power cable to the Thor VM3 dock
8. Secure the power cable to the Thor VM3 using the
9.
10. If using the
11. Press the
12. Press the
Thor VM3 with Microsoft Windows Embedded Compact 7 User Guide
be turned Off. The power cable must be UNPLUGGED from the dock.
possible to the actual battery terminals of the vehicle (if using unswitched power).
Properly sized "crimp" type electrical terminals are an accepted method of
termination. Please select electrical connectors sized for use with 20AWG
(0.81mm2) conductors.
• Ignition Control Wiring Diagram
• Auto-On Control Wiring Diagram
• Manual Control Wiring Diagram
cable is rated for a maximum temperature of 105°C (221°F). Therefore, when
routing this cable it should be protected from physical damage and from surfaces
that might exceed this temperature. Cable should be protected from physical
damage from moving parts. Do not expose the cable to chemicals or oil that may
cause the wiring insulation to deteriorate. Always route the cable so that it does not
interfere with safe operation and maintenance of the vehicle.
approximately one foot intervals, taking care not to over tighten and pinch
conductors or penetrate outer cable jacket.
power connector by aligning the connector pins to the power connector; push down
on the watertight connector and twist it to fasten securely.
Place Thor VM3 in the Dock
Screen Blanking
Power Switch
Power Button
Fuse Requirements, connect the power cable as close as
feature, install the screen blanking box or switch.
on the back of the Thor VM3 dock.
on the front of the Thor VM3 to turn on the Thor VM3.
Strain Relief Cable Clamps.
77