Power Controls - Honeywell Thor VM3 User Manual

Power Controls

Power Switch
Standard Dock
Power Button
Power Configuration Mode
The Power Configuration Mode control panel is used to select desired power configura-
tion behavior.
Please refer to the
For information on the Ignition input signal see
Connection
32
Enhanced Dock
Power Configuration Mode
and Auto-On Control Wiring
Thor VM3 with Microsoft Windows Embedded Compact 7 User Guide
After all cables are connected, the Thor VM3
can be powered on.
There is a power switch located on the back of
the dock. The power switch is a rocker switch.
The power switch has a raised bump to identify
the switch position even when it is hidden from
view. When the side of the switch with the
raised bump is pressed, the power switch is
On. If the dock is connected to external power,
the dock delivers power to the Thor VM3.
Generally, once the dock is powered On, there
is no need to power it off. The dock power can
remain On even when the Thor VM3 is not
attached.
The power button is located at the lower left
of the Thor VM3.
If the Thor VM3 is Off, pressing the power
button starts the power up sequence.
Note: This assumes that the Thor VM3 is
docked in a powered dock or that the
internal UPS battery has a sufficient
charge to power the Thor VM3. If no
external power is available and the UPS
battery does not have a charge,
pressing the power button causes no
action.
If the Thor VM3 is On, pressing the power
button places the unit in Suspend.
control panel for complete details.
Vehicle 10-60VDC Direct Power
Diagram.