Honeywell Thor VM3 User Manual page 115

DC/DC Power Supply with Screws on Top of Lid
Caution: Inspect the cable shield to verify it is connected to chassis
For this model, follow the diagram below to attach the power cable shield to
chassis ground:
Caution: For battery powered vehicles:
•
•
Thor VM3 with Microsoft Windows Embedded Compact 7 User Guide
ground. If there is no connection from the cable shield to
chassis ground, one must be added at this time. Use a jumper
wire to connect the cable shield to chassis ground as shown
below for the appropriate type of power supply installed on the
vehicle. A jumper wire, as shown in the illustrations below, may
be present to attach the chassis ground to the white wire of the
power cable. This wire is not necessary but can be left in place
if present. For proper screen blanking, verify the yellow and
green wires are attached to the screen blanking box as shown
in the illustrations below.
Existing Circuitry on Vehicle
Forklift Battery
Main Switch
+Vo -Vo
10A slow fuse
Close to power
source
+ -
+
-
DC/DC
Power
Supply
+ is connected to battery positive.
- must be connected to battery negative.
MOTION
CIRCUITRY
3A fuse
Green
Yellow
Brown
White
Supplied Power Cable
(Shielding to be trimmed)
VMX004VMCRADLE
Vehicle Mount
Smart Dock
5
6
Circular
Power
Connector
1
3
103