Factory Default Vlan Definition - Zhone zNID-GPON-2402 Configuration Manual

Factory default VLAN definition

Table 31 shows the VLANs set as the factory defaults
Table 31: Factory default VLANs
VLAN Type Tagged/Untagged
7 Bridged Tagged
100 Bridged Tagged
Bridged
200 Tagged
200 Bridged Untagged
300 Bridged Tagged
VLAN 7 is the default management VLAN. The fiber uplink ports are tagged
members of this VLAN. The ONU is also configured to have DHCP enabled
on VLAN 7. With this arrangement, the 24xx can be connected to the MXK
and is ready to be remotely managed on VLAN 7 and pass data on VLAN 200
without any further configuration needed on the 24xx.
All downstream gigabit Ethernet interfaces have the Port VLAN ID (PVID)
set to 200 by default. VLAN 200, the default data VLAN is also set as the
PVID for the wireless SSID 0 (wl0).
Figure 58: Default VLAN and port interface settings
For more information about PVID see
Figure 59 shows how the default interfaces from
displayed in the Web UI.
Factory default VLAN definition
Port
eth0 (Fiber WAN
– GPON or GigE)
eth0 (Fiber WAN
– GPON or GigE)
eth0 (Fiber WAN
– GPON or GigE)
GE1 to GE4
(GigE)
eth0 (Fiber WAN
– GPON or GigE)
Edit Port Defaults on page
Figure 58 and
zNID 24xx Series Configuration Guide
IP address
DHCP enabled
n/a
n/a
Static,
192.168.1.1
n/a
145.
Figure 31 are
87